Helpdesk / Technical Support Details
plug&playsecurity
Swann Technical Support
All Countries E-mail: [email protected]
Telephone Helpdesk
Advanced security made easy™
USA toll free
1-800-627-2799
AUSTRALIA toll free
1300 138 324
Home Outdoor Security Kit
1 Real & 1 Imitation Camera
PNP-150/2D™
(Su, 2pm-10pm US PT)
(M-Th, 6am-10pm US PT)
(F 6am-2pm US PT)
USA Exchange & Repairs
562-777-2551
(M 9am-5pm AUS ET)
(Tu-F 1am-5pm AUS ET)
(Sa 1am-9am AUS ET)
NEW ZEALAND toll free
0800 479 266
(M-F, 9am-5pm US PT)
INTERNATIONAL
+61 3 8412 4610
current time in Melbourne, Australia compared to your local time.
Warranty Information
Swann Communications USA Inc.
12636 Clark Street
Swann Communications PTY. LTD.
Building 4, 650 Church Street,
Richmond, Victoria 3121
Australia
Santa Fe Springs CA 90670
USA
Swann Communications warrants this product against defects in workmanship and material
for a period of one (1) year from it’s original purchase date. You must present your receipt
as proof of date of purchase for warranty validation. Any unit which proves defective during
the stated period will be repaired without charge for parts or labour or replaced at the sole
discretion of Swann. The end user is responsible for all freight charges incurred to send the
product to Swann’s repair centres. The end user is responsible for all shipping costs incurred
when shipping from and to any country other than the country of origin.
The warranty does not cover any incidental, accidental or consequential damages arising
from the use of or the inability to use this product. Any costs associated with the fitting or
removal of this product by a tradesman or other person or any other costs associated with
its use are the responsibility of the end user. This warranty applies to the original purchaser
of the product only and is not transferable to any third party. Unauthorized end user or
third party modifications to any component or evidence of misuse or abuse of the device will
render all warranties void.
Quick Start Guide
By law some countries do not allow limitations on certain exclusions in this warranty. Where
applicable by local laws, regulations and legal rights will take precedence.
SW212-HXD
SR212-HXD-10006-040609
© Swann Communications 2009
Table of Contents
Before You Begin
Viewing the Camera on Your TV or VCR
Viewing the PNP-150 on a TV
2
After connecting the PNP-150 Camera directly to your TV and powering it on as
described on page 4, tune the TV to the correct input channel.
Table of Contents
3
On your TV’s remote control, the input button is usually labelled as Input, Source,
A/V, Channel 0, AUX etc.*
Package Contents
3
Connection Guide
4-5
6
Viewing and Recording the PNP-150 on a VCR
Connect the PNP-150 into an available input channel on your VCR in the same
manner as the TV connection listed on page 4. Turn on your VCR and TV as if
you were about to play a VCR tape.
Viewing the Camera on Your TV or VCR
Tips & Suggestions
6
On your VCR’s remote control, find the input button with is usually labelled as L1,
L2, Input, Source, A/V, Channel, 0, AUX etc.* Insert a tape and push record to
record the camera.
Troubleshooting Guide
Helpdesk / Technical Support Details
Warranty Information
7
8
*Consult the TV or VCR instruction manual for details about changing input
channels
8
Tips & Suggestions
Package Contents
Never aim the camera directly at the sun as it may damage the sensor
PNP-150 Security Camera
PNP-150 Imitation Camera
Camera Stand x 2
Power Adapter
Test all connections and ensure the camera is working correctly prior to permanent
installation
Quick Start Guide
Security Stickers
Install cameras high enough or out of reach to avoid tampering
BNC Extension Cable
BNC to RCA Adapter
Mounting Hardware
Place Security Stickers in a visible location to alert potential thieves they are being
monitored
Mix real cameras with dummy cameras to give the impression of increased security
coverage
plug&playsecurity
Advanced security made easy™
Home Outdoor Security Kit
1
Real
&
1
Imitation Camera
Purchase a Swann DVR to record multiple cameras simultaneously and easily moni-
tor your property.
PNP-150/2D™
Place cameras in high traffic areas such as doorways to maximise security
Use only the included Power Supply and do not modify or cut wires
Quick Start Guide
SW212-HXD
SR212-HXD-10006
EN140109
6
3
Connection Guide
Plug in the Camera
Power Adapter
4
Connect the Extension
Cable to the Power
3Adapter
Connect the camera
cable to the Extension
1Cable
2A. Connecting Directly to TV
2B. Connecting to Your Existing DVR
Connect the BNC Extension
Cable to an open channel on
2the back of the DVR
Connect the BNC to RCA
Adapter and connect to Video
2Input on your TV or VCR
INPUT
4
5
|